Getting Started: FurLuxe
Your FurLuxe is a professional injection bathing system. Water flows through the pump — shampoo enters via a separate line and is never in contact with the pump. Follow these steps to connect, prime, and start bathing.
What’s in the Box
FurLuxe main unit (fully assembled) · High-flex fan cone nozzle · Flexible wash hose with application wand · 16oz SudCell shampoo bottle with hookup line · Faucet aerator to hose adapter kit · Water hookup line · Power cord · Window cling
Connect Water Supply
Choose Your Connection
Connect the water supply line to the H2O port on the machine. The water line can connect to a faucet aerator adapter, a hose bib, or a PrimaPod tank.
Faucet Connection
Attach the included faucet aerator adapter to your sink faucet, then connect the water line. Turn on the faucet to test — the machine controls water flow, not the faucet.
Connect Hoses
Water Supply → H2O Port
Connect the water supply line to the H2O port on the rear of the machine.
SudCell Line → MIX Port
Connect the SudCell shampoo bottle hookup line to the MIX port. Attach the other end to the SudCell cap.
Sprayer → WAND Port
Connect the flexible wash hose and spray wand to the WAND port.
Power
Connect the power cord to the rear of the machine and plug into a GFCI outlet.
Shampoo Setup — Dilution Guide
The FurLuxe dilutes shampoo at a 16:1 baseline ratio. If your shampoo has a higher dilution ratio, pre-dilute it in the SudCell to match the 16:1 baseline before use.
| Shampoo Ratio | 16oz SudCell | 64oz SudCell | 128oz SudCell |
|---|---|---|---|
| 16:1 | Do not dilute | Do not dilute | Do not dilute |
| 24:1 | 12oz shampoo | 48oz shampoo | 96oz shampoo |
| 32:1 | 8oz shampoo | 32oz shampoo | 64oz shampoo |
| 40:1 | 6.7oz shampoo | 26.7oz shampoo | 53.3oz shampoo |
| 48:1 | 5.3oz shampoo | 18.7oz shampoo | 37.3oz shampoo |
| 64:1 | 4oz shampoo | 16oz shampoo | 32oz shampoo |
Priming the System
Power On
Switch on the machine to activate the system.
Prime the Water Line
Press the wand trigger to let air purge from the lines. Loosen the nozzle slightly to create a stream — this helps water fill the system faster. Once the machine sprays steadily, release the trigger. The machine shuts off automatically after a moment.
Prime the Mix Line
Turn on Apply mode and spray again with the nozzle slightly loose. Once shampoo begins to flow, tighten the nozzle to increase pressure and widen the spray cone.
Daily Use
Apply Shampoo
Start with machine set to Apply mode. The oxygenated flow lifts dirt and dander from the root of the coat outward.
Let It Sit
Allow suds to sit for a few minutes to maximize cleaning effectiveness.
Rinse
Switch off Apply mode to rinse. Allow a few seconds for shampoo to clear the lines before clean water flows through.
End of Day — Cleanup
Wipe down the exterior with a soft cloth to remove water, shampoo, or residue.
Purge the shampoo line: Remove the SudCell intake tube from the shampoo container and place it in a bucket of clean water. Switch to Mix mode and spray for 15–30 seconds until only clean water flows through.
Power down and store in a clean, dry area.