Getting Started: EV2 (Encore V2)

• ✓

  EV2 main unit

• ✓

  Wall mounting bracket + screws + threaded drywall sleeves

• ✓

  Two bound hoses (H2O + POD) and one separate hose (WND / sprayer wand)

• ✓

  Elbow fittings (only needed for freestanding use — not required for wall mount)

• ✓

  Sprayer wand with nozzle

• ✓

  Power cord

• ✓

  Premix bucket (or use your own)

• 1

  Hold the bracket against the wall with the “TOP” marking facing up. Use a level to make sure it is plumb (straight up and down).

• 2

  For best strength, mount into a wall stud. If a stud is not available, use the included threaded drywall sleeves — drive them in with a Phillips screwdriver bit and drill.

• 3

  Install the top screw first, leaving it slightly loose so the bracket can hang naturally and find plumb on its own.

• 4

  Mark the bottom hole location, then swing the bracket out of the way. Install the drywall sleeve (if needed) or confirm stud position.

• 5

  Swing the bracket back into place, install the bottom screw, then tighten both screws securely.

• 1

  Remove the small screw from the recessed hole at the bottom rear of the EV2 — this is where the unit locks onto the bracket.

• 2

  Lift the machine and align the rear of the housing with the installed wall bracket. The back of the housing is designed to nest around the bracket.

• 3

  Lower the machine so it slides down onto the bracket until it is fully seated.

• 4

  Reinstall the small screw into the recessed hole at the bottom and tighten securely. This locks the unit to the bracket and prevents it from lifting off.

• 1

  Connect the two bound hoses to the H2O and POD ports on the machine, and the other ends into your premix bucket.

• 2

  Connect the separate hose to the WND port and attach the other end to your sprayer wand.

• 3

  Push each hose firmly into its fitting until fully seated, then tug lightly to confirm it is secure.

The EV2 uses a premix system — you mix your shampoo with water in the bucket before connecting. The system is based on a 16:1 dilution baseline. If your shampoo has a higher dilution ratio, pre-dilute it in the bucket to match 16:1.

Before bathing, you need to prime both the water line and the shampoo line to purge any air.

• 1

  Power on the machine. Press the trigger on the wand to let air purge from the lines. Tip: loosen the nozzle slightly to create a stream rather than a spray — this helps water fill the system faster.

• 2

  Once the machine is spraying steadily, release the trigger. The machine will shut off automatically after a moment. Your water line is primed.

• 3

  Switch to Apply Mode. Begin spraying again with the nozzle slightly loosened. Once you see shampoo begin to flow, tighten the nozzle to increase pressure and widen the spray cone.

• 4

  If the machine starts to chug or pulse, the nozzle is too tight — loosen it slightly until the spray stabilizes. You’re now ready to bathe!